H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Information Center
H3C S7500E Series Ethernet Switches Chapter 1 Information Center Configuration
1-15
 Note:
z To ensure that the device works normally, use the info-center logfile size-quota
command to set a logfile to be no smaller than 1 MB and no larger than 10 MB.
z Use the info-center logfile switch-directory command to manually configure the
directory to which a log file can be saved. The configuration will be invalid after
system reboot or the primary/backup switchover.
1.2.9 Configuring Synchronous Information Output
Synchronous information output refers to the feature that if the user’s input is
interrupted by system output such as log, trap, or debugging information, then after the
completion of system output the system will display a command line prompt (a prompt
in command editing mode, or a [Y/N] string in interaction mode) and your input so far.
This command is used in the case that your input is interrupted by a large amount of
system output. With this feature enabled, you can continue your operations from where
you were stopped.
Follow these steps to enable synchronous information output:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable synchronous
information output
info-center
synchronous
Required
Disabled by default
 Note:
z If system information, such as log information, is output before you input any
information under the current command line prompt, the system will not display the
command line prompt after the system information output.
z If system information is output when you are inputting some interactive information
(non Y/N confirmation information), then after the system information output, the
system will not display the command line prompt but your previous input in a new
line.