H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches Chapter 1 Basic Configurations
1-7
To do… Use the command… Remarks
Configure the banner to be displayed before
login
header motd text
Optional
1.1.5 Configuring CLI Hotkeys
Follow these steps to configure CLI hotkeys:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure CLI hotkeys
hotkey { CTRL_G |
CTRL_L | CTRL_O |
CTRL_T | CTRL_U }
command
Optional
The <Ctrl+G>, <Ctrl+L> and
<Ctrl+O> hotkeys are
specified with command lines
by default.
Display hotkeys
display hotkey
Available in any view. Refer
to Table 1-2 for hotkeys
reserved by the system.
 Note:
By default, the <Ctrl+G>, <Ctrl+L> and <Ctrl+O> hotkeys are configured with command
line and the <Ctrl+T> and <Ctrl+U> commands are NULL.
z <Ctrl+G> corresponds to the display current-configuration command.
z <Ctrl+L> corresponds to the display ip routing-table command.
z <Ctrl+O> corresponds to the undo debugging all command.
Table 1-2 Hotkeys reserved by the system
Hotkey Function
<Ctrl+A> Moves the cursor to the beginning of the current line.
<Ctrl+B> Moves the cursor one character to the left.
<Ctrl+C> Stops performing a command.
<Ctrl+D> Deletes the character at the current cursor position.
<Ctrl+E> Moves the cursor to the end of the current line.
<Ctrl+F> Moves the cursor one character to the right.
<Ctrl+H> Deletes the character to the left of the cursor.
<Ctrl+K> Terminates an outgoing connection.