H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches Chapter 1 Basic Configurations
1-9
Table 1-3 Default command levels
Level Privilege Command
0 Visit ping, tracert, telnet
1 Monitor refresh, reset, send
2 System All configuration commands except for those at manage level
3 Manage FTP, TFTP, Xmodem, and file system operation commands
Follow these steps to configure user level and command level:
To do… Use the command… Remarks
Switch the user level super [ level ]
Optional
Available in user view.
Enter system view
system-view
—
Configure the password
for switching the user
level
super password [ level
user-level ] { simple |
cipher } password
Optional
By default, no password is
configured.
Configure the command
level in system view
command-privilege
level level view view
command
Optional
 Note:
The commands available depend on your user level when you log onto a device. For
example, if your user level is 3 and the command level of VTY 0 interface is 1, you can
use commands below level 3 (inclusive).