H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches Chapter 2 System Maintaining and Debugging
2-3
OFF
ON
OFF
ON
Debugging
information
Protocol
debugging
switch
Screen
output
switch
1
3
1 2 3
OFF
ON
ON
1
3
1 2 3
1
3
Debugging
information
Screen
output
switch
Protocol
debugging
switch
Figure 2-1 The relationship between the protocol and screen debugging switch
 Note:
Displaying debugging information on the terminal is the most commonly used way to
output debugging information. You can also output debugging information to other
directions. For details, refer to Information Center Configuration.
2.2 System Maintaining and Debugging
2.2.1 System Maintaining
To do… Use the command… Remarks
ping [ ip ] [ -a source-ip | -c
count | -f | -h ttl | -i
interface-type
interface-number | -m interval
| -n | -p pad | -q | -r | -s
packet-size | -t timeout | -tos
tos | -v ] * remote-system
Optional
Used in IPv4 network
Available in any view
Check whether a
specified IP address
can be reached
ping ipv6 [ -a source-ipv6 | -c
count | -m interval | -s
packet-size | -t timeout ] *
remote-system [ -i
interface-type
interface-number ]
Optional
Used in IPv6 network
Available in any view