H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches Chapter 3 Device Management
3-5
If you repeatedly insert and remove different subcards or interface cards to create or
delete a large amount of logical interface, the interface indexes will be used up, which
will result in interface creation failures. To avoid such a case, you can clear all 16bit
interface indexes saved but not used in the current system in user view.
After the above operation,
z for a re-created interface, the new interface index may not be consistent with the
original one.
z for existing interfaces, their interface indexes remain unchanged.
Follow the step below to clear the 16bit interface indexes not used in the current
system:
To do… Use the command… Remarks
Clear the 16-bit interface
indexes saved but not used
in the current system
reset unused porttag
Required
Execute the command in
user view.
Caution:
A confirmation is required when you execute this command. If you fail to make a
confirmation within 30 seconds or enter “N” to cancel the operation, the command will
not be executed.
3.2.7 Configuring the Traffic Forwarding Mode of SRPUs
I. Introduction to SRPU traffic forwarding mode
The S7500E series Ethernet switches support multiple types of SRPUs, which support
different traffic forwarding modes. You can configure the SRPU traffic forwarding mode
as needed.