H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches Chapter 3 Device Management
3-8
 Note:
z The S7500E series Ethernet switches support multiple types of LPUs, where only
EA LPUs support working mode configuration.
z The working mode configuration of an LPU does not affect the service processing
capability of the whole switch, but that of the LPU only.
II. Configuring the working mode of EA LPUs
Follow these steps to configure the working mode of an EA LPU:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the
working mode of an
EA LPU
switch-mode { bridging |
routing } slot slot-num
Optional
By default, the working mode of
an EA LPU is determined by the
SRPU model and the current
traffic forwarding mode of the
SRPU. Refer to
Table 3-2 for
details.
Table 3-2 Default working mode of EA LPUs
SRPU model
Current traffic
forwarding mode of the
SRPU
Default working mode
of EA LPUs
LSQ1SRP2XB,
LSQ1SRPB, LSQ1MPUA
l2-enhanced or standard
routing
l2-enhanced or
standard-bridging
bridging
LSQ1SRP1CB
standard-routing routing