H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – VLAN

H3C S7500E Series Ethernet Switches Chapter 4 GVRP Configuration

4-10

[DeviceB-Ethernet2/0/1] gvrp

[DeviceB-Ethernet2/0/1] quit

# Create VLAN 3 (a static VLAN).

[Sysname] vlan 3

3) Verify the configuration

# Display dynamic VLAN information on Device A.

[DeviceA] display vlan dynamic

No dynamic vlans exist!

# Display dynamic VLAN information on Device B.

[DeviceB] display vlan dynamic

Now, the following dynamic VLAN exist(s):

4.4.3 GVRP Configuration Example III

I. Network requirements

To prevent dynamic VLAN information registration and update among devices, set the

GVRP registration mode to forbidden on Device A and normal on Device B.

II. Network diagram

Figure 4-4 Network diagram for GVRP configuration

III. Configuration procedure

1) Configure Device A

# Enable GVRP globally.

<DeviceA> system-view

[DeviceA] gvrp

# Configure port Ethernet 2/0/1 as a trunk port, allowing all VLANs to pass.

[DeviceA] interface ethernet 2/0/1

[DeviceA-Ethernet2/0/1] port link-type trunk

[DeviceA-Ethernet2/0/1] port trunk permit vlan all

# Enable GVRP on the port.

[DeviceA-Ethernet2/0/1] gvrp

# Set the GVRP registration type to forbidden on the port.

[DeviceA-Ethernet2/0/1] gvrp registration forbidden