H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – HA
H3C S7500E Series Ethernet Switches Chapter 1 VRRP Configuration
1-27
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111
# Configure the priority of Switch A in standby group 1 to 110.
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110
# Create a standby group 2 and set its virtual IP address to 202.38.160.112.
[SwitchA-Vlan-interface2] vrrp vrid 2 virtual-ip 202.38.160.112
2) Configure Switch B
# Configure VLAN 2.
<SwitchB> system-view
[SwitchB] vlan 2
[SwitchB-vlan2] port GigabitEthernet 2/0/5
[SwitchB-vlan2] quit
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.0
# Create a standby group 1 and set its virtual IP address to 202.38.160.111.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111
# Create a standby group 2 and set its virtual IP address to 202.38.160.112.
[SwitchB-Vlan-interface2] vrrp vrid 2 virtual-ip 202.38.160.112
# Configure the priority of Switch B in standby group 2 to 110.
[SwitchB-Vlan-interface2] vrrp vrid 2 priority 110
3) Verify the configuration
You can use the display vrrp command to verify the configuration.
# Display detailed information of the standby group on Switch A.
[SwitchA-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Interface : Vlan-interface2
VRID : 1 Adver. Timer : 1
Admin Status : UP State : Master
Config Pri : 110 Run Pri : 110
Preempt Mode : YES Delay Time : 0
Auth Type : NONE
Virtual IP : 202.38.160.111
Virtual MAC : 0000-5e00-0101
Master IP : 202.38.160.1
Interface : Vlan-interface2
VRID : 2 Adver. Timer : 1
Admin Status : UP State : Backup