H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – RRPP
H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration
1-11
1.4 Configuring Transit Node
1.4.1 Configuration Procedure
Follow these steps to configure transit node:
To do… Use the command… Remarks
Enter system view
system-view
—
Create an RRPP domain
and enter its view
rrpp domain domain-id
Required
Specify a control VLAN for
the RRPP domain
control-vlan vlan-id
Required
Specify the current device
as the transit node of the
ring, and specify the
primary port and the
secondary port
ring ring-id node-mode
transit [ primary-port
interface-type
interface-number ]
[ secondary-port
interface-type
interface-number ] level
level-value
Required
Enable the RRPP ring
ring ring-id enable
Required
By default, the RRPP ring
is disabled.
Return to system view
quit
—
Enable RRPP
rrpp enable
Required
By default, RRPP is
disabled.
Caution:
z The control VLAN configured for an RRPP domain must be a new one.
z Control VLAN configuration is required for configuring an RRPP ring.
z To use the undo rrpp domain command to remove an RRPP domain, you must
ensure the RRPP domain has no RRPP ring.
1.4.2 Transit Node Configuration Example
I. Network requirements
z Specify the device in RRPP domain 1;
z Set VLAN 4092 as the control VLAN;