H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – RRPP
H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration
1-12
z Specify the device as the transit node of primary ring 1 in RRPP domain 1,
GigabitEthernet 3/0/1 as the primary port and GigabitEthernet 3/0/2 as the
secondary port.
II. Configuration procedure
<Sysname> system-view
[Sysname] interface gigabitethernet 3/0/1
[Sysname-GigabitEthernet3/0/1] link-delay 0
[Sysname-GigabitEthernet3/0/1] quit
[Sysname] interface gigabitethernet 3/0/2
[Sysname-GigabitEthernet3/0/2] link-delay 0
[Sysname-GigabitEthernet3/0/2] quit
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 4092
[Sysname-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet
3/0/1 secondary-port gigabitethernet 3/0/2 level 0
[Sysname-rrpp-domain1] ring 1 enable
[Sysname-rrpp-domain1] quit
[Sysname] rrpp enable
1.5 Configuring Edge Node
1.5.1 Configuration Procedure
Follow these steps to configure edge node:
To do… Use the command… Remarks
Enter system view
system-view
—
Create an RRPP domain
and enter its view
rrpp domain domain-id
Required
Specify a control VLAN for
the RRPP domain
control-vlan vlan-id
Required
Specify the current device
as the transit node of the
primary ring, and specify
the primary port and the
secondary port
ring ring-id node-mode
transit [ primary-port
interface-type
interface-number ]
[ secondary-port
interface-type
interface-number ] level
level-value
Required
Specify the current device
as the edge node of a
subring, and specify the
common port and the
edge port
ring ring-id node-mode
edge [ common-port
interface-type
interface-number ]
[ edge-port interface-type
interface-number ]
Required