H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – RRPP
H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration
1-14
[Sysname-GigabitEthernet3/0/1] link-delay 0
[Sysname-GigabitEthernet3/0/1] quit
[Sysname] interface gigabitethernet 3/0/2
[Sysname-GigabitEthernet3/0/2] link-delay 0
[Sysname-GigabitEthernet3/0/2] quit
[Sysname] interface gigabitethernet 3/0/4
[Sysname-GigabitEthernet3/0/4] link-delay 0
[Sysname-GigabitEthernet3/0/4] quit
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 4092
[Sysname-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet
3/0/1 secondary-port gigabitethernet 3/0/2 level 0
[Sysname-rrpp-domain1] ring 2 node-mode edge common-port gigabitethernet
3/0/2 edge-port gigabitethernet 3/0/4
[Sysname-rrpp-domain1] ring 1 enable
[Sysname-rrpp-domain1] ring 2 enable
[Sysname-rrpp-domain1] quit
[Sysname] rrpp enable
1.6 Configuring Assistant Edge Node
1.6.1 Configuration Procedure
Follow these steps to configure assistant edge node:
To do… Use the command… Remarks
Enter system view
system-view
—
Create an RRPP domain
and enter its view
rrpp domain domain-id
Required
Specify a control VLAN for
the RRPP domain
control-vlan vlan-id
Required
Specify the current device
as the transit node of the
primary ring, and specify
the primary port and the
secondary port
ring ring-id node-mode
transit [ primary-port
interface-type
interface-number ]
[ secondary-port
interface-type
interface-number ] level
level-value
Required
Specify the current device
as the assistant edge
node of the subring, and
specify a common port
and an edge port
ring ring-id node-mode
assistant-edge
[ common-port
interface-type
interface-number ]
[ edge-port interface-type
interface-number ]
Required