H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – RRPP
H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration
1-15
To do… Use the command… Remarks
Enable the primary ring
ring ring-id enable
Required
By default, the RRPP ring
is disabled.
Enable the subring
ring ring-id enable
Required
By default, the RRPP ring
is disabled.
Return to system view
quit
—
Enable RRPP
rrpp enable
Required
By default, RRPP is
disabled.
Caution:
z The control VLAN configured for an RRPP domain must be a new one.
z Control VLAN configuration is required for configuring an RRPP ring.
z A Ring ID cannot be applied to more than on RRPP ring in an RRPP domain.
z You must first configure the primary ring and then the subring when configuring an
edge node. Moreover, you must remove all subring configurations before deleting
the primary ring configuration of an edge node. However, the RRPP ring enabled
cannot be deleted.
z To use the undo rrpp domain command to remove an RRPP domain, you must
ensure the RRPP domain has no RRPP ring.
1.6.2 Assistant Edge Node Configuration Example
I. Networking requirements
z Specify the device in RRPP domain 1;
z Set VLAN 4092 as the control VLAN;
z Specify the device as the transit node of primary ring 1 in RRPP domain 1,
GigabitEthernet 3/0/1 as the primary port and GigabitEthernet 3/0/2 as the
secondary port;
z Specify the device as the assistant edge node of subring 2 in RRPP domain 1,
GigabitEthernet 3/0/2 as the common port and GigabitEthernet 3/0/4 as the edge
port.
II. Configuration procedure
<Sysname> system-view
[Sysname] interface gigabitethernet 3/0/1