H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – RRPP
H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration
1-19
4) Perform the following configuration on Device D:
<Device D> system-view
[DeviceD] interface gigabitethernet 3/0/1
[DeviceD-GigabitEthernet3/0/1] link-delay 0
[DeviceD-GigabitEthernet3/0/1] quit
[DeviceD] interface gigabitethernet 3/0/2
[DeviceD-GigabitEthernet3/0/2] link-delay 0
[DeviceD-GigabitEthernet3/0/2] quit
[Device D] rrpp domain 1
[Device D-rrpp-domain1] control-vlan 4092
[Device D-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet
3/0/1 secondary-port gigabitethernet 3/0/2 level 0
[Device D-rrpp-domain1] ring 1 enable
[Device D-rrpp-domain1] quit
[Device D] rrpp enable
After the above configuration, you can use the display command to view RRPP
configuration.
1.8.2 Configuring Single-Domain Intersecting Ring Topology
I. Networking requirements
z Device A, Device B, Device C and Device D constitute RRPP domain 1.
z VLAN 4092 is the control VLAN of RRPP domain 1;
z Device A, Device B, Device C and Device D constitute primary ring 1;
z Device B, Device C and Device E constitute subring 2;
z Device A is the master node of primary ring 1, GigabitEthernet 3/0/1 is the primary
port and GigabitEthernet 3/0/2 is the secondary port;
z Device E is the master node of subring 2, GigabitEthernet 3/0/1 is the primary port
and GigabitEthernet 3/0/2 is the secondary port;
z Device B is the transit node of primary ring 1 and the edge node of subring 2,
GigabitEthernet 3/0/2 is the common port and GigabitEthernet 3/0/3 is the edge
port;
z Device C is the transit node of primary ring 1 and the assistant edge node of
subring 1, GigabitEthernet 3/0/1 is the common port and GigabitEthernet 3/0/3 is
the edge port;
z Device D is the transit node of primary ring 1, GigabitEthernet 3/0/1 is the primary
port and GigabitEthernet 3/0/2 is the secondary port;
z The timers of both the primary ring and the subring adopt the default value.