H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – RRPP

H3C S7500E Series Ethernet Switches Chapter 1 RRPP Configuration

1-20

Figure 1-7 Networking diagram for single-domain intersecting rings configuration

II. Configuration considerations

First, determine the primary ring and subring in an RRPP domain, node mode of a

device on each RRPP ring, and then perform the following configuration on a

per-device basis:

z Create an RRPP domain.

z Specify the control VLAN for the RRPP domain.

z Specify the node mode of a device on an RRPP ring and the ports accessing the

RRPP ring on the device.

z Enable these two RRPP rings.

z Enable RRPP

III. Configuration procedure

1) Perform the following configuration on Device A:

<Device A> system-view

[DeviceA] interface gigabitethernet 3/0/1

[DeviceA-GigabitEthernet3/0/1] link-delay 0

[DeviceA-GigabitEthernet3/0/1] quit

[DeviceA] interface gigabitethernet 3/0/2

[DeviceA-GigabitEthernet3/0/2] link-delay 0

[DeviceA-GigabitEthernet3/0/2] quit

[Device A] rrpp domain 1

[Device A-rrpp-domain1] control-vlan 4092

[Device A-rrpp-domain1] ring 1 node-mode master primary-port gigabitethernet

3/0/1 secondary-port gigabitethernet 3/0/2 level 0

[Device A-rrpp-domain1] ring 1 enable

[Device A-rrpp-domain1] quit