H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches Table of Contents
i
Table of Contents
Chapter 1 Port Correlation Configuration................................................................................... 1-1
1.1 Ethernet Port Configuration ............................................................................................... 1-1
1.1.1 Performing Basic Ethernet Port Configuration ........................................................ 1-1
1.1.2 Enabling Flow Control on an Ethernet Port............................................................. 1-2
1.1.3 Configuring the Suppression Time of Physical-Link-State Change on an Ethernet
Port...................................................................................................................................
1-3
1.1.4 Enabling Loopback Test on an Ethernet Port ......................................................... 1-3
1.1.5 Configuring a Port Group ........................................................................................ 1-4
1.1.6 Configuring the Broadcast/Multicast/Unknown Unicast Storm Suppression Ratio for
an Ethernet Port ...............................................................................................................
1-5
1.1.7 Setting the Interval for Collecting Ethernet Port Statistics ...................................... 1-6
1.1.8 Enabling the Forwarding of Jumbo Frames ............................................................ 1-7
1.1.9 Enabling Loopback Detection on an Ethernet Port................................................. 1-8
1.1.10 Configuring the Cable Type for an Ethernet Port.................................................. 1-9
1.1.11 Configuring the Storm Constrain Function on an Ethernet Port ........................... 1-9
1.2 Maintaining and Displaying an Ethernet Port .................................................................. 1-11
Chapter 2 Port Isolation Configuration ....................................................................................... 2-1
2.1 Introduction to Port Isolation .............................................................................................. 2-1
2.2 Configuring an Isolation Group .......................................................................................... 2-1
2.2.1 Adding a Port to an Isolation Group........................................................................ 2-1
2.3 Displaying Isolation Groups ............................................................................................... 2-2
2.4 Port Isolation Configuration Example ................................................................................ 2-2