H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches Chapter 1 Port Correlation Configuration
1-1
Chapter 1 Port Correlation Configuration
When configuring Ethernet ports, go to these sections for information you are
interested in:
z Ethernet Port Configuration
z Maintaining and Displaying an Ethernet Port
1.1 Ethernet Port Configuration
Complete the following tasks to configure an Ethernet port:
Task Remarks
Performing Basic Ethernet Port Configuration Optional
Enabling Flow Control on an Ethernet Port Optional
Configuring the Suppression Time of Physical-Link-State Change
on an Ethernet Port
Optional
Enabling Loopback Test on an Ethernet Port Optional
Configuring a Port Group Optional
Configuring the Broadcast/Multicast/Unknown Unicast Storm
Suppression Ratio for an Ethernet Port
Optional
Setting the Interval for Collecting Ethernet Port Statistics Optional
Enabling the Forwarding of Jumbo Frames Optional
Enabling Loopback Detection on an Ethernet Port Optional
Configuring the Cable Type for an Ethernet Port Optional
Configuring the Storm Constrain Function on an Ethernet Port Optional
1.1.1 Performing Basic Ethernet Port Configuration
Three types of duplex modes are available to Ethernet ports:
z Full-duplex mode (full). Ports operating in this mode can send and receive packets
simultaneously.
z Half-duplex mode (half). Ports operating in this mode can either send or receive
packets at a given time.
z Auto-negotiation mode (auto). Ports operating in this mode determine their duplex
mode through auto-negotiation.