H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Link Aggregation
H3C S7500E Series Ethernet Switches Chapter 2 Link Aggregation Configuration
2-1
Chapter 2 Link Aggregation Configuration
When configuring link aggregation, go to these sections for information you are
interested in:
z Configuring Link Aggregation
z Displaying and Maintaining Link Aggregation
z Link Aggregation Configuration Example
2.1 Configuring Link Aggregation
This section covers these topics:
z Configuring a Manual Link Aggregation Group
z Configuring a Static LACP Link Aggregation Group
z Configuring an Aggregation Group Name
z Configuring a Service Loop Group
z Entering Aggregation Port Group View
2.1.1 Configuring a Manual Link Aggregation Group
Follow these steps to create a manual aggregation group and add an Ethernet port to it:
To do… Use the command… Remarks
Enter system view
system-view
––
Create a manual
aggregation group
link-aggregation group agg-id
mode manual
Required
Enter Ethernet port view
interface interface-type
interface-number
––
Assign the Ethernet port
to the aggregation group
port link-aggregation group
agg-id
Required
Note that:
z You can create a manual aggregation group by changing the type of an existing
static aggregation group. When you create a manual aggregation group in this
way and the static aggregation group contains ports, LACP is disabled on the
ports after the manual aggregation group is created.
z An aggregation group cannot contain the following ports: RRPP-enabled ports,
ports configured with static MAC addresses or black hole MAC addresses, voice
VLAN-enabled ports, or 802.1x-enabled ports.
z After you remove a manual aggregation group, all the ports in the group are
dismissed from it.