H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Link Aggregation
H3C S7500E Series Ethernet Switches Chapter 2 Link Aggregation Configuration
2-5
To do… Use the command… Remarks
Display detailed
information about
specified or all link
aggregation groups
display link-aggregation
verbose [ agg-id ]
Available in any view
Clear the statistics about
LACP for specified or all
ports
reset lacp statistics
[ interface interface-type
interface-number [ to
interface-type
interface-number ] ]
Available in user view
2.3 Link Aggregation Configuration Example
I. Network requirements
z Switch A aggregates ports Ethernet 2/0/1 through Ethernet 2/0/3 to form one link
connected to Switch B and performs load sharing among these ports.
z Create a tunnel service-loop group and add port Ethernet 2/0/1 to the group.
II. Network diagram
Figure 2-1 Network diagram for link aggregation configuration
III. Configuration procedure
 Note:
This example only describes how to configure link aggregation on Switch A. To achieve
link aggregation, do the same on Switch B.
1) In manual aggregation approach
# Create manual aggregation group 1.
<SwitchA> system-view
[SwitchA] link-aggregation group 1 mode manual