H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – MSTP
H3C S7500E Series Ethernet Switches Chapter 1 MSTP Configuration
1-19
Task Remarks
Configuring an MST Region Required
Configuring the Work Mode of MSTP Device Optional
Configuring the Timeout Factor Optional
Configuring the Maximum Transmission Rate of Ports Optional
Configuring Ports as Edge Ports Optional
Configuring Path Costs of Ports Optional
Configuring Port Priority Optional
Configuring Whether Ports Connect to Point-to-Point Links Optional
Configuring the Mode a Port Uses to Recognize/Send
MSTP Packets
Optional
Enabling the Output of Port State Transition Information Optional
Configurin
g Leaf
Nodes
Enabling the MSTP Feature Required
Performing mCheck Optional
Configuring Digest Snooping Optional
Configuring No Agreement Check Optional
Configuring Protection Functions Optional
 Note:
In a network containing switches with both GVRP and MSTP enabled, GVRP
messages travel along the CIST. If you want to advertise a VLAN through GVRP, be
sure to map the VLAN to the CIST (MSTI 0) when configuring the VLAN-to-MSTI
mapping table. For detailed information of GVRP, refer to GVRP Configuration.
1.3 Configuring the Root Bridge
1.3.1 Configuring an MST Region
I. Configuration procedure
Follow these steps to configure an MST region:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter MST region view
stp region-configuration
—