H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration
2-12
To do… Use the command… Remarks
Enter system view
system-view
––
Enter RIP view rip [ process-id ] ––
Configure a priority for
RIP
preference [ route-policy
route-policy-name ] value
Optional
100 by default
2.3.7 Configuring RIP Route Redistribution
Follow these steps to configure RIP route redistribution:
To do… Use the command… Remarks
Enter system view
system-view
––
Enter RIP view rip [ process-id ] ––
Configure a default
metric for
redistributed routes
default-cost value
Optional
The default metric of a
redistributed route is 0 by
default.
Redistribute routes
from another protocol
import-route protocol
[ process-id ] [ allow-ibgp ]
[ cost cost | route-policy
route-policy-name | tag tag ] *
Required
No redistribution is
configured by default.
2.4 Configuring RIP Network Optimization
Complete the following tasks before configuring RIP network optimization:
z Configure network addresses for interfaces, and make neighboring nodes
reachable to each other;
z Configure RIP basic functions.
2.4.1 Configuring RIP Timers
Follow these steps to configure RIP timers:
To do… Use the command… Remarks
Enter system view
system-view
––
Enter RIP view rip [ process-id ] ––