H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration
2-17
2.5 Displaying and Maintaining RIP
To do… Use the command… Remarks
Display RIP current status
and configuration
information
display rip [ process-id ]
Display all active routes in
RIP database
display rip process-id database
Display RIP interface
information
display rip process-id interface
[ interface-type interface-number ]
Display routing
information about a
specified RIP process
display rip process-id route
[ statistics | ip-address { mask |
mask-length } | peer ip-address ]
Available in any
view
Clear the statistics of a
RIP process
reset rip process-id statistics
Available in
user view
2.6 RIP Configuration Examples
2.6.1 Configuring RIP Version
I. Network requirements
As shown in Figure 2-4, enable RIPv2 on all interfaces on Switch A and Switch B.
II. Network diagram
Figure 2-4 Network diagram for RIP version configuration
III. Configuration procedure
1) Configure IP addresses for interfaces (omitted).
2) Configure basic RIP functions
# Configure Switch A.
<SwitchA> system-view
[SwitchA] rip
[SwitchA-rip-1] network 192.168.1.0
[SwitchA-rip-1] network 172.16.0.0
[SwitchA-rip-1] network 172.17.0.0