H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 3 OSPF Configuration
3-22
Task Remarks
Configuring OSPF Packet
Timers
Optional
Specifying an LSA Transmission
Delay
Optional
Specifying SPF Calculation
Interval
Optional
Specifying the LSA Minimum
Repeat Arrival Interval
Optional
Specifying the LSA Generation
Interval
Optional
Disabling Interfaces from
Sending OSPF Packets
Optional
Configuring Stub Routers Optional
Configuring OSPF
Authentication
Optional
Adding the Interface MTU into
DD Packets
Optional
Configuring the Maximum
Number of External LSAs in
LSDB
Optional
Making External Route Selection
Rules Defined in RFC1583
Compatible
Optional
Logging Neighbor State
Changes
Optional
Configuring OSPF
Network Optimization
Configuring OSPF Network
Management
Optional
3.3 Configuring OSPF Basic Functions
You need to enable OSPF, specify an interface and area ID first before performing other
tasks.
3.3.1 Prerequisites
Before configuring OSPF, you need to configure IP addresses for interfaces, making
neighboring nodes accessible with each other at the network layer.
3.3.2 Configuration Procedure
z Configure a Router ID