H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Login
H3C S7500E Series Ethernet Switches Chapter 3 Logging in Through Telnet
3-1
Chapter 3 Logging in Through Telnet
When logging in through Telnet, go to these sections for information you are interested
in:
z Introduction
z Telnet Configuration with Authentication Mode Being None
z Telnet Configuration with Authentication Mode Being Password
z Telnet Configuration with Authentication Mode Being Scheme
z Telnet Connection Establishment
3.1 Introduction
You can telnet to a remote switch to manage and maintain the switch. To achieve this,
you need to configure both the switch and the Telnet terminal properly.
Table 3-1 Requirements for Telnet to a switch
Item Requirement
Start the Telnet Server
The IP address of the VLAN of the switch is configured and the
route between the switch and the Telnet terminal is available.
(Refer to the module “IP Addressing and Performance” and “IP
Routing” for more.)
Switch
The authentication mode and other settings are configured.
Refer to
Table 3-2 and Table 3-3.
Telnet is running.
Telnet terminal
The IP address of the management VLAN of the switch is
available.