H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration
5-51
Paths: 1 available, 1 best
BGP routing table entry information of 9.1.1.0/24:
From : 200.1.2.1 (1.1.1.1)
Original nexthop: 200.1.2.1
Community : No-Export
AS-path : 10
Origin : igp
Attribute value : MED 0, pref-val 0, pre 255
State : valid, external, best,
Not advertised to any peers yet
The route 9.1.1.0/24 is not available in the routing table of Switch C.
5.9.5 BGP Route Reflector Configuration
I. Network requirements
In the following figure, all switches run BGP.
z Between Switch A and Switch B is an EBGP connection, between Switch C and
Switch B, and between Switch C and Switch D are IBGP connections.
z Switch C is a route reflector with clients Switch B and D.
z Switch D can learn route 1.0.0.0/8 from Switch C.
II. Network diagram
Figure 5-20 Network diagram for BGP route reflector configuration
III. Configuration procedure
1) Configure IP addresses for interfaces (omitted)
2) Configure BGP connections
# Configure Switch A.
<SwitchA> system-view
[SwitchA] bgp 100