H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Login
H3C S7500E Series Ethernet Switches Chapter 3 Logging in Through Telnet
3-6
To do… Use the command… Remarks
Set the timeout time of the
VTY user interface
idle-timeout minutes
[ seconds ]
Optional
The default timeout time
of a user interface is 10
minutes.
With the timeout time
being 10 minutes, the
connection to a user
interface is terminated if
no operation is performed
in the user interface within
10 minutes.
You can use the
idle-timeout 0 command
to disable the timeout
function.
Note that if you configure not to authenticate the users, the command level available to
users logging into a switch depends on both the authentication-mode none command
and the user privilege level level command, as listed in
Table 3-4.
Table 3-4 Determine the command level when users logging into switches are not
authenticated
Scenario
Authentication
mode
User type Command
Command
level
The user privilege level
level command not executed
Level 0
None
(authentication-
mode none)
VTY users
The user privilege level
level command already
executed
Determined
by the level
argument
3.2.2 Configuration Example
I. Network requirements
Assume that you are a level 3 AUX user and want to perform the following configuration
for Telnet users logging into VTY 0:
z Do not authenticate users logging into VTY 0.
z Commands of level 2 are available to users logging into VTY 0.
z Telnet protocol is supported.
z The screen can contain up to 30 lines.
z The history command buffer can contain up to 20 commands.
z The timeout time of VTY 0 is 6 minutes.