H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 1 IPv6 Static Routing Configuration
1-2
1.2.1 Configuration prerequisites
z Enabling IPv6 packet forwarding
z Ensuring that the neighboring nodes are IPv6 reachable
1.2.2 Configuring an IPv6 Static Route
Follow these steps to configure an IPv6 static route:
To do... Use the commands… Remarks
Enter system view
System-view
—
Configure an IPv6
static route
ipv6 route-static ipv6-address
prefix-length [ interface-type
interface-number ] nexthop-address
[ preference preference-value ]
Required
The default
preference of IPv6
static routes is 60.
1.3 Displaying and Maintaining IPv6 Static Routes
To do... Use the command... Remarks
Display IPv6 static route
information
display ipv6 routing-table
protocol static [ inactive |
verbose ]
Available in any view
Remove all IPv6 static
routes
delete ipv6 static-routes all
Available in system view
 Note:
Using the undo ipv6 route-static command can delete a single IPv6 static route, while
using the delete ipv6 static-routes all command deletes all IPv6 static routes
including the default route.
1.4 IPv6 Static Routing Configuration Example
I. Network requirements
With IPv6 static routes configured, all hosts and switches can interact with each other.