H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 2 IPv6 RIPng Configuration
2-6
To do... Use the command... Remarks
Enter system view
system-view
––
Enter interface view
interface interface-type
interface-number
––
Advertise a default
route
ripng default-route { only |
originate } [ cost cost ]
Required
Not advertised by default
 Note:
With this feature enabled, a default route is advertised via the specified interface
regardless of whether the default route is available in the local IPv6 routing table.
2.3.4 Configuring a RIPng Route Filtering Policy
You can reference a configured IPv6 ACL or prefix list to filter received/advertised
routing information as needed. For filtering outbound routes, you can also specify a
routing protocol from which to filter routing information redistributed.
Follow these steps to configure a RIPng route filtering policy:
To do... Use the command... Remarks
Enter system view
system-view
––
Enter RIPng view ripng [ process-id ] ––
Configure a filter policy
to filter incoming
routes
filter-policy { acl6-number |
ipv6-prefix
ipv6-prefix-name } import
Required
By default, RIPng does
not filter incoming routing
information.
Configure a filter policy
to filter outgoing routes
filter-policy { acl6-number |
ipv6-prefix
ipv6-prefix-name } export
[ protocol [ process-id ] ]
Required
By default, RIPng does
not filter outgoing routing
information.
2.3.5 Configuring a Priority for RIPng
Any routing protocol has its own protocol priority used for optimal route selection. You
can set a priority for RIPng manually. The smaller the value is, the higher the priority is.
Follow these steps to configure a RIPng priority: