H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 2 IPv6 RIPng Configuration
2-10
2.4.4 Configuring the Maximum Number of Equal Cost Routes for Load
Balancing
Follow these steps to configure the maximum number of equal cost RIPng routes for
load balancing:
To do... Use the command... Remarks
Enter system view
system-view
––
Enter RIPng view ripng [ process-id ] ––
Configure the maximum number of
equal cost RIPng routes for load
balancing
maximum
load-balancing number
Optional
4 by default
2.5 Displaying and Maintaining RIPng
To do... Use the command... Remarks
Display configuration
information of a RIPng process
display ripng
[ process-id ]
Available in any
view
Display routes in the RIPng
database
display ripng process-id
database
Available in any
view
Display the routing information
of a specified RIPng process
display ripng process-id
route
Available in any
view
Display RIPng interface
information
display ripng process-id
interface [ interface-type
interface-number ]
Available in any
view
2.6 RIPng Configuration Example
I. Network requirements
As shown in Figure 2-4, all switches run RIPng. Configure Switch B to filter the route
(3::/64) learnt from Switch C, which means the route will not be added to the routing
table of Switch B, and Switch B will not forward it to Switch A.
II. Network diagram
Figure 2-4 Network diagram for RIPng configuration