H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration
3-9
To do... Use the command... Remarks
Specify the maximum
number of load-balanced
routes
maximum
load-balancing
maximum
Optional
4 by default
3.5.6 Configuring a Priority for OSPFv3
A router may run multiple routing protocols. The system assigns a priority for each
protocol. When these routing protocols find the same route, the route found by the
protocol with the highest priority is selected.
Follow these steps to configure a priority for OSPFv3:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter OSPFv3 view ospfv3 [ process-id ]
—
Configure a priority
for OSPFv3
preference [ ase ]
[ route-policy
route-policy-name ]
preference
Optional
By default, the priority of
OSPFv3 interval routes is 10,
and priority of OSPFv3 external
routes is 150.
3.5.7 Configuring OSPFv3 Route Redistribution
Follow these steps to configure OSPFv3 route redistribution:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter OSPFv3 view ospfv3 [ process-id ]
—
Specify a default cost
for redistributed routes
default cost value
Optional
Defaults to 1
Redistribute routes
from another protocol,
or another OSPFv3
process
import-route { isisv6 process-id |
ospfv3 process-id | ripng
process-id | bgp4+ [ allow-ibgp ] |
direct | static } [ cost value | type
type | route-policy
route-policy-name ] *
Required
Not configured by
default
Configure the filtering
of outgoing
redistributed routes
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ isisv6 process-id | ospfv3
process-id | ripng process-id |
bgp4+ | direct | static ]
Optional
Not configured by
default