H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration
3-13
To do... Use the command... Remarks
Enter system view
system-view
—
Enter OSPFv3 view ospfv3 [ process-id ]
—
Enable the logging on
neighbor state changes
log-peer-change
Required
Enabled by default
3.7 Displaying and Maintaining OSPFv3
To do... Use the command... Remarks
Display OSPFv3
debugging state
information
display debugging ospfv3
Display OSPFv3 process
brief information
display ospfv3 [ process-id ]
Display OSPFv3 interface
information
display ospfv3 interface [ interface-type
interface-number | statistic ]
Display OSPFv3 LSDB
information
display ospfv3 [ process-id ] lsdb
[ [ external | inter-prefix | inter-router |
intra-prefix | link | network | router ]
[ link-state-id ] [ originate-router router-id ]
| total ]
Display LSA statistics in
OSPFv3 LSDB
display ospfv3 lsdb statistic
Display OSPFv3 neighbor
information
display ospfv3 [ process-id ] [ area
area-id ] peer [ [ interface-type
interface-number ] [ verbose ] |
peer-router-id ]
Display OSPFv3 neighbor
statistics
display ospfv3 peer statistic
Display OSPFv3 routing
table information
display ospfv3 [ process-id ] routing
[ ipv6-address prefix-length |
ipv6-address/prefix-length | abr-routes |
asbr-routes | all | statistics ]
Display OSPFv3 area
topology information
display ospfv3 [ process-id ] topology
[ area area-id ]
Display OSPFv3 virtual
link information
display ospfv3 [ process-id ] vlink
Display OSPFv3 next hop
information
display ospfv3 [ process-id ] next-hop
Available
in any
view