H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration
3-23
3) Use the display ospfv3 lsdb command to display Link State Database
information to check integrity.
4) Display information about area configuration using the display
current-configuration configuration command. If more than two areas are
configured, at least one area is connected to the backbone.
5) In a Stub area, all routers are configured with the stub command.
6) If a virtual link is configured, use the display ospf vlink command to check the
neighbor state.