H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IPv6 IS-IS Configuration
4-2
4.2 Configuring IPv6 IS-IS Basic Functions
 Note:
You can implement IPv6 inter-networking through configuring IPv6 IS-IS in IPv6
network environment.
4.2.1 Configuration Prerequisites
Before the configuration, accomplish the following tasks first:
z Enable IPv6 globally
z Configure IP addresses for interfaces, and make sure all neighboring nodes are
reachable.
z Enable IS-IS
4.2.2 Configuration Procedure
Follow these steps to configure the basic functions of IPv6 IS-IS:
To do... Use command to… Remarks
Enter system view
system-view
––
Enable an IS-IS process
and enter IS-IS view
isis [ process-id ]
Required
Not enabled by default
Configure the network
entity title for the IS-IS
process
network-entity net
Required
Not configured by default
Enable IPv6 for the IS-IS
process
ipv6 enable
Required
Disabled by default
Return to system view
quit
––
Enter interface view
interface interface-type
interface-number
––
Enable IPv6 for an IS-IS
process on the interface
isis ipv6 enable
[ process-id ]
Required
Disabled by default