H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration
5-3
Task Remarks
Configuring IPv6 BGP Peer Group Optional
Configuring IPv6 BGP Community Optional
Configuring a Large
Scale IPv6 BGP
Network
Configuring an IPv6 BGP Route
Reflector
Optional
5.3 Configuring IPv6 BGP Basic Functions
5.3.1 Prerequisites
Before configuring this task, you need to:
z Specify IP addresses for interfaces.
z Enable IPv6.
 Note:
You need create a peer group before configuring basic functions for it. For related
information, refer to
Configuring IPv6 BGP Peer Group.
5.3.2 Configuring an IPv6 Peer
Follow these steps to configure an IPv6 peer:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
Required
Not enabled by default
Specify a router ID
router-id router-id
Optional
Required if no IP
addresses configured for
Loopback interface and
other interfaces
Enter IPv6 address family
view
ipv6-family —
Specify an IPv6 peer and
its AS number
peer ipv6-address
as-number as-number
Required
Not configured by default