H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration
5-7
To do... Use the command... Remarks
Enter IPv6 address family
view
ipv6-family —
Disable session
establishment to a
peer/peer group
peer { ipv6-group-name |
ipv6-address } ignore
Optional
Not disabled by default
5.3.9 Logging Peer State Changes
Follow these steps to configure to log on the session and event information of a
peer/peer group:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
Required
Enable logging of peer
changes globally
log-peer-change
Optional
Enabled by default
Enter IPv6 address family
view
ipv6-family —
Enable the state change
logging for a peer or peer
group
peer { ipv6-group-name |
ipv6-address }
log-change
Optional
Enabled by default
 Note:
Refer to the part discussing IPv4 routing commands for information about the
log-peer-change command.
5.4 Controlling Route Distribution and Reception
The task includes routing information filtering, routing policy application and route
dampening.
5.4.1 Prerequisites
Before configuring this task, you have:
z Enabled the IPv6 function
z Configured the IPv6 BGP basic functions