H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration
5-15
To do... Use the command... Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
Required
Enter IPv6 address family
view
ipv6-family —
Specify
keepalive
interval and
holdtime
timer keepalive
keepalive hold holdtime
Configure
IPv6 BGP
timers
Configure
keepalive
interval and
holdtime for a
peer/peer
group
peer { ipv6-group-name |
ipv6-address } timer
keepalive keepalive hold
holdtime
Optional
The keepalive interval
defaults to 60 seconds,
holdtime defaults to 180
seconds.
Configure the interval for
sending the same update to
a peer/peer group
peer { ipv6-group-name |
ipv6-address }
route-update-interval
seconds
Optional
The interval for sending
the same update to an
IBGP peer or an EBGP
peer defaults to 15
seconds or 30 seconds
 Note:
z Timers configured using the timer command have lower priority than timers
configured using the peer timer command.
z The holdtime interval must be at least three times the keepalive interval.
5.6.3 Configuring IPv6 BGP Soft Reset
I. Enable route refresh
Follow these steps to enable route refresh:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
Required
Enter IPv6 address
family view
ipv6-family —