H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration
5-18
To do... Use the command... Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
Required
Not enabled by default
Enter IPv6 address
family view
ipv6-family —
Create an IBGP peer
group
group ipv6-group-name
[ internal ]
Required
Add a peer into the
group
peer ipv6-address group
ipv6-group-name
[ as-number as-number ]
Required
Not added by default
II. Create a pure EBGP peer group
Follow these steps to configure a pure EBGP group:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
Required
Not enabled by default
Enter IPv6 address family
view
ipv6-family —
Create an EBGP peer
group
group ipv6-group-name
external
Required
Configure the AS number
for the peer group
peer ipv6-group-name
as-number as-number
Required
Not configured by default
Add an IPv6 peer into the
peer group
peer ipv6-address group
ipv6-group-name
Required
Not added by default
 Note:
z To create a pure EBGP peer group, you need to specify an AS number for the peer
group.
z If a peer was added into an EBGP peer group, you cannot specify any AS number
for the peer group.
III. Create a mixed EBGP peer group
Follow these steps to create a mixed EBGP peer group: