H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration
5-20
II. Apply a routing policy to routes advertised to a peer/peer group
Follow these steps to apply a routing policy to routes advertised to a peer/peer group:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
Required
Enter IPv6 address family
view
ipv6-family —
Apply a routing policy to
routes advertised to a
peer/peer group
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
Required
Not applied by default
 Note:
When configuring IPv6 BGP community, you need to configure a routing policy to
define the community attribute, and apply the routing policy to route advertisement.
5.7.4 Configuring an IPv6 BGP Route Reflector
Follow these steps to configure an IPv6 BGP route reflector:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
Required
Enter IPv6 address family
view
ipv6-family —
Configure the router as a
route reflector and specify
a peer/peer group as a
client
peer { ipv6-group-name |
ipv6-address }
reflect-client
Required
Not configured by default
Enable route reflection
between clients
reflect between-clients
Optional
Enabled by default
Configure the cluster ID
of the route reflector
reflector cluster-id
cluster-id
Optional
By default, a route
reflector uses its router ID
as the cluster ID