H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration
5-21
 Note:
z In general, since the route reflector forwards routing information between clients, it
is not required to make clients of a route reflector fully meshed. If clients are fully
meshed, it is recommended to disable route reflection between clients to reduce
routing costs.
z If a cluster has multiple route reflectors, you need to specify the same cluster ID for
these route reflectors to avoid routing loops.
5.8 Displaying and Maintaining IPv6 BGP Configuration
5.8.1 Displaying BGP
To do... Use the command... Remarks
Display IPv6 BGP peer
group information
display bgp ipv6 group
[ ipv6-group-name ]
Display IPv6 BGP
advertised routing
information
display bgp ipv6 network
Display IPv6 BGP AS
path information
display bgp ipv6 paths
[ as-regular-expression ]
Display IPv6 BGP
peer/peer group
information
display bgp ipv6 peer
[ ipv6-group-name log-info |
ipv6-address { log-info | verbose } |
verbose ]
Display IPv6 BGP routing
table information
display bgp ipv6 routing-table
[ ipv6-address prefix-length ]
Display IPv6 BGP routing
information matching an
AS path ACL
display bgp ipv6 routing-table
as-path-acl as-path-acl-number
Display IPv6 BGP
community routing
information
display bgp ipv6 routing-table
community [ aa:nn<1-13> ]
[ no-advertise | no-export |
no-export-subconfed ]*
[ whole-match ]
Display IPv6 BGP routing
information matching an
IPv6 BGP community list
display bgp ipv6 routing-table
community-list
{ basic-community-list-number
[ whole-match ] |
adv-community-list-number }&<1-16>
Display dampened IPv6
BGP routing information
display bgp ipv6 routing-table
dampened
Available
in any view