H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 6 Routing Policy Configuration
6-9
 Note:
The apply ipv6 next-hop commands do not apply to redistributed IPv6 routes
respectively.
6.4 Displaying and Maintaining the Routing Policy
To do... Use the command... Remarks
Display IPv6 BGP AS
path ACL information
display ip as-path [ as-path-number ]
Display IPv6 BGP
community list information
display ip community-list
[ basic-community-list-number |
adv-community-list-number ]
Display IPv6 BGP
extended community list
information
display ip extcommunity-list
[ ext-comm-list-number ]
Display IPv6 prefix list
statistics
display ip ipv6-prefix
[ ipv6-prefix-name ]
Display routing policy
information
display route-policy
[ route-policy-name ]
Clear IPv6 prefix statistics reset ip ipv6-prefix [ ipv6-prefix-name ]
Available in
any view
6.5 Routing Policy Configuration Example
6.5.1 Applying Routing Policy When Redistributing IPv6 Routes
I. Network requirements
z Enable RIPng on Switch A and Switch B.
z Configure three static routes on Switch A and apply a routing policy when
redistributing static routes, making routes 20::0/32 and 40::0/32 pass, routes in
30::0/32 filtered out.
z Display RIPng routing table information on Switch B to verify the configuration.