H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 1 IPv6 Basics Configuration
1-24
To do… Use the command… Remarks
Clear IPv6 dynamic domain
name cache information
reset dns ipv6 dynamic-host
Available
in user
view
Clear IPv6 neighbor
information
reset ipv6 neighbors { all | dynamic
| interface interface-type
interface-number | slot slot-number |
static }
Clear the corresponding
PMTU
reset ipv6 pathmtu { all | static |
dynamic}
Clear the statistics of IPv6
and ICMPv6 packets
reset ipv6 statistics [ slot
slot-number ]
Clear all IPv6 TCP
connection statistics
reset tcp ipv6 statistics
Clear the statistics of all IPv6
UDP packets
reset udp ipv6 statistics
Available
in user
view
 Note:
The display dns domain command is the same as the one of IPv4 DNS. For details
about the commands, refer to DNS Commands.
1.10 IPv6 Configuration Example
I. Network requirements
Two switches are directly connected through two Ethernet ports. The Ethernet ports
belong to VLAN 2. Configure different types of IPv6 addresses for VLAN-interface 2
respectively on Switch A and Switch B to verify the connectivity between two switches.
The IPv6 prefix in the EUI-64 format is 2001::/64. Specify the aggregatable global
unicast address of Switch A as 3001::1/64, and the aggregatable global unicast
address of Switch B as 3001::2/64.
II. Network diagram
Figure 1-6 Network diagram for IPv6 address configuration
III. Configuration procedure
z Configuration on Switch A