H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 3 Tunneling Configuration
3-5
To do… Use the command… Remarks
Create a tunnel interface and
enter tunnel interface view
interface tunnel
number
Required
By default, there is no
tunnel interface on the
device.
ipv6 address
{ ipv6-address
prefix-length |
ipv6-address/prefix-len
gth }
Configure a
global unicast
IPv6 address or a
site-local address
ipv6 address
ipv6-address/prefix-len
gth eui-64
Required
Use any command.
By default, no IPv6
global unicast address
or site-local address is
configured for the
tunnel interface.
ipv6 address auto
link-local
Configure
an IPv6
address for
the tunnel
interface
Configure a
link-local IPv6
address
ipv6 address
ipv6-address link-local
Optional
A link-local address
will automatically be
created when an IPv6
global unicast address
or site-local address is
configured.
Specify the IPv6 manual tunnel
mode
tunnel-protocol
ipv6-ipv4
Required
By default, the tunnel
mode is manual. The
same tunnel type
should be configured
at both ends of the
tunnel. Otherwise,
packet delivery will fail.
Configure a source address or
interface for the tunnel
source { ip-address |
interface-type
interface-number }
Required
By default, no source
address or interface is
configured for the
tunnel.
Configure a destination address
for the tunnel
destination ip-address
Required
By default, no
destination address is
configured for the
tunnel.
Reference an aggregation
group
aggregation-group
aggregation-group-id
Required
By default, no link
aggregation group ID
is referenced.