H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 3 Tunneling Configuration
3-12
3.4.3 Configuration Example
I. Network requirements
Isolated IPv6 networks are interconnected through a 6to4 tunnel over the IPv4 network.
II. Network diagram
Figure 3-4 Network diagram for a 6to4 tunnel
III. Configuration procedure
z Configuration on Switch A
# Enable IPv6.
<SwitchA> system-view
[SwitchA] ipv6
# Configure a link aggregation group. Disable STP on the port before adding it into the
link aggregation group.
[SwitchA] link-aggregation group 1 mode manual
[SwitchA] link-aggregation group 1 service-type tunnel
[SwitchA] interface Ethernet 3/0/1
[SwitchA-Ethernet3/0/1] stp disable
[SwitchA-Ethernet3/0/1] port link-aggregation group 1
[SwitchA-Ethernet3/0/1] quit
# Configure an IPv4 address for VLAN-interface 100.
[SwitchA] vlan 100
[SwitchA-vlan100] port ethernet 3/0/1
[SwitchA-vlan100] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 2.1.1.1 24
[SwitchA-Vlan-interface100] quit