H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 2 IGMP Snooping Configuration
2-11
To do... Use the command... Remarks
Configure member port
aging time
igmp-snooping
host-aging-time interval
Optional
260 seconds by default
2.4.3 Configuring Static Ports
If all the hosts attached to a port are interested in the multicast data addressed to a
particular multicast group or the multicast data that a particular multicast source sends
to a particular group, you can configure static (*, G) or (S, G) joining on that port,
namely configure the port as a group-specific or source-and-group-specific static
member port.
You can configure a port of a switch to be a static router port, through which the switch
can forward all the multicast traffic it received.
Follow these steps to configure static ports:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter Ethernet
port view
interface interface-type
interface-number
Enter the
corresponding
view
Enter port
group view
port-group { manual
port-group-name |
aggregation agg-id }
Required
Use either
command.
Configure the port(s) as static
member port(s)
igmp-snooping
static-group group-address
[ source-ip
source_address ] vlan
vlan-id
Required
Disabled by
default
Configure the port(s) as static
router port(s)
igmp-snooping
static-router-port vlan
vlan-id
Required
Disabled by
default
 Note:
z The static (S, G) joining function is available only if a valid multicast source address
is specified and IGMP Snooping version 3 is currently running on the switch.
z A static member port does not respond to queries from the IGMP querier; when
static (*, G) or (S, G) joining is enabled or disabled on a port, the port does not send
an unsolicited IGMP report or an IGMP leave group message.
z Static member ports and static router ports never age out. To remove such a port,
you need to use the corresponding command.