H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 2 IGMP Snooping Configuration
2-19
To do... Use the command... Remarks
Enable multicast source
port filtering
source-deny port
interface-list
Required
Disabled by default
II. Configuring multicast source port filtering on a port or a group of ports
Follow these steps to configure multicast source port filtering on a port or a group of
ports:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter Ethernet
port view
interface interface-type
interface-number
Enter the
corresponding
view
Enter port
group view
port-group { manual
port-group-name |
aggregation agg-id }
Required
Use either command.
Enable multicast source port
filtering
igmp-snooping
source-deny
Required
Disabled by default
 Note:
When the S7500E series Ethernet switches are enabled to filter IPv4 multicast data
based on the source ports, they are automatically enabled to filter IPv6 multicast data
based on the source ports.
2.6.4 Configuring the Function of Dropping Unknown Multicast Data
Unknown multicast data refers to multicast data for which no entries exist in the IGMP
Snooping forwarding table. When the switch receives such multicast traffic:
z With the function of dropping unknown multicast data enabled, the switch drops all
the unknown multicast data received.
z With the function of dropping unknown multicast data disabled, the switch floods
unknown multicast data in the VLAN which the unknown multicast data belongs to.
I. Configuring globally the function of dropping unknown multicast data
Follow these steps to configure globally the function of dropping unknown multicast
data: