H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 6 MSDP Configuration
6-10
6.3.2 Enabling MSDP
Follow these steps to enable MSDP:
To do... Use the command... Remarks
Enter system view
system-view
—
Enable IP multicast
routing
multicast
routing-enable
Required
Disabled by default
Enable MSDP and enter
MSDP view
msdp
Required
Disabled by default
6.3.3 Creating an MSDP Peer Connection
An MSDP peering relationship is identified by an address pair, namely the address of
the local MSDP peer and that of the remote MSDP peer. An MSDP peer connection
must be created on both devices that are a pair of MSDP peers.
Follow these steps to create an MSDP peer connection:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter MSDP view
msdp
—
Create an MSDP peer
connection
peer peer-address
connect-interface
interface-type
interface-number
Required
No MSDP peer
connection created by
default
 Note:
If an interface of the router is shared by an MSDP peer and a BGP peer at the same
time, we recommend that you configuration the same IP address for the MSDP peer
and BGP peer.
6.3.4 Configuring a Static RPF Peer
Configuring static RPF peers avoids RPF check of SA messages.
Follow these steps to configure a static RPF peer: