H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 6 MSDP Configuration
6-24
II. Network diagram
Vlan-int101
Vl
an
-
int102
Switch B
Switch A
Source 1
AS 100
PIM-SM 1
PIM-SM 3
PIM-SM 2
Loop0
Switch C
Switch D
Switch E
Switch F
Source 2
Vlan-int100
Vl
a
n-
int103
Vlan-int101
Vlan-int104
Vlan-int105
Loop0
Receiver
Receiver
Loop0
Static RPF peers
Vl
an-
int1
03
Vl
a
n-
int200
Vlan-int104
Vlan-int105
Vlan-
i
n
t30
0
Vla
n
-int400
AS 200
Vlan-i
n
t102
Device Interface IP address Device Interface IP address
Switch A Vlan-int103 10.110.1.2/24 Switch D Vlan-int104 10.110.4.2/24
Vlan-int100 10.110.2.1/24 Vlan-int300 10.110.5.1/24
Vlan-int200 10.110.3.1/24 Switch E Vlan-int105 10.110.6.1/24
Switch B Vlan-int103 10.110.1.1/24 Vlan-int102 192.168.3.2/24
Vlan-int101 192.168.1.1/24 Loop0 3.3.3.3/32
Vlan-int102 192.168.3.1/24 Switch F Vlan-int105 10.110.6.2/24
Loop0 1.1.1.1/32 Vlan-int400 10.110.7.1/24
Switch C Vlan-int101 192.168.1.2/24 Source 1 — 10.110.2.100/24
Vlan-int104 10.110.4.1/24 Source 2 — 10.110.5.100/24
Loop0 2.2.2.2/32
Figure 6-6 Network diagram for inter-AS multicast configuration leaveraging static
RPF peers
III. Configuration procedure
1) Configure the interface IP addresses and unicast routing protocol for each switch
Configure the IP address and subnet mask for each interface as per
Figure 6-6.
Detailed configuration steps are omitted here.
Configure OSPF for interconnection between the switches. Ensure the network-layer
interoperation in each AS, and ensure the dynamic update of routing information
among the switches through a unicast routing protocol. Detailed configuration steps are
omitted here.
2) Enable IP multicast routing, enable PIM-SM and IGMP, and configure a PIM-SM
domain border
# Enable IP multicast routing on Switch A, enable PIM-SM on each interface, and
enable IGMP on the host-side interface VLAN-interface 200.