H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 1 VLAN Configuration
1-10
To do… Use the command… Remarks
Enter system view
system-view
—
Enter
Ethernet
port view
interface interface-type
interface-number
Enter
Ethernet
port view
or port
group
view
Enter port
group view
port-group { manual
port-group-name |
aggregation agg-id }
Use either command;
Under Ethernet port view,
the subsequent
configurations only apply
to the current port; under
port group view, the
subsequent
configurations apply to all
the ports in the port group
Configure the port link
type as Hybrid
port link-type hybrid
Required
By default, a port is of the
Access type.
Configure the port to
permit packets of
specific VLANs
port hybrid vlan
vlan-id-list { tagged |
untagged }
Required
By default, a Hybrid port
only permits the packets
of VLAN 1.
Configure the default
VLAN of the Hybrid port
port hybrid pvid vlan
vlan-id
Optional
VLAN 1 by default
 Note:
z To configure a Trunk port into a Hybrid port (or vice versa), you need to use the
Access port as a medium. For example, the Trunk port has to be configured as an
Access port first and then a Hybrid port.
z Ensure that a VLAN already exists before configuring it to pass through a certain
Hybrid port.
z The default VLAN ID on the Hybrid ports of the local and the peer devices must be
the same. Otherwise, packets cannot be transmitted properly.
1.5 Configuring Protocol-Based VLAN
1.5.1 Introduction to Protocol-Based VLAN
 Note:
Protocol-based VLANs are only applicable to hybrid ports.