H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 1 VLAN Configuration
1-12
To do… Use the command… Remarks
Enter
Ethernet port
view
interface interface-type
interface-number
Enter
Ethernet
port
view or
port
group
view
Enter port
group view
port-group { manual
port-group-name |
aggregation agg-id }
Use either command
Under Ethernet port view,
the subsequent
configurations only apply
to the current port; under
port group view, the
subsequent configurations
apply to all ports in the port
group
Configure the port link
type as Hybrid
port link-type hybrid
Required
Allow the packets of a
protocol-based VLAN to
pass through the current
Hybrid port in untagged
way
port hybrid vlan
vlan-id-list untagged
Required
Configure the
association between the
Hybrid port and the
protocol-based VLAN
port hybrid
protocol-vlan vlan
vlan-id { protocol-index
[ to protocol-end ] | all }
Required
Caution:
z At present, the AppleTalk-based protocol template cannot be associated with a port
on an S7500E series Ethernet switch
z You cannot configure the dsap-id and ssap-id argument in the protocol-vlan
command as 0xe0 at the same time. 0xe0 corresponds to the ipx llc protocol
template. Similarly, do not configure the dsap-id and ssap-id argument as 0xff at the
same time as well. 0xff corresponds to the ipx raw protocol template.
z Ensure that the ethernetii etype etype-id keyword and argument combination is not
configured as 0x0800, 0x8137, 0x809b, or 0x86dd, because they correspond to
IPv4, IPX, AppleTalk and IPv6 protocol template respectively.
z Do not configure a VLAN as a protocol-based VLAN and a voice VLAN under
automatic mode at the same time, as the former requires the Hybrid port to untag
packets, whereas the latter requires the Hybrid port to tag packets. For more
information, refer to
Voice VLAN Configuration.