H3C S7502 Ethernet Switch Installation Manual

Installation Manual
H3C S7502 Ethernet Switch Chapter 7 Software Maintenance
7-9
The following describes how to load the software when the S7502 switch functions as a
TFTP client.
II. Loading Boot ROM
Step 1: Connect the switch to the PC,, which saves the file to be downloaded, through
the Ethernet port for management and upgrade. The IP address of the PC is required.
Connect the switch to another PC through the Console port. The two PCs can be the
same one.
Step 2: Run the TFTP Server program on the PC connected to the Ethernet port, and
specify the path for program loading.
Caution:
z TFTP Server program is not shipped with the S7502 switch.
z When loading Boot ROM and host software, you must use a crossover cable to
connect to the Ethernet port for upgrading.
Step 3: Run terminal emulation program on the PC that is connected to the console port.
Start the switch, enter the Boot Menu, and then enter the download protocol menu.
To download the Boot ROM program, press <Ctrl+U> and <Enter> to access the menu
for Boot ROM downloading when the system displays “Enter your choice(0-5):”
SRPG bootrom update menu:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):1
Step 4: In the download protocol menu, type <1> to select TFTP protocol to download
Boot ROM or host software. Press <Enter> and the system displays the following
information:
Load File name:
Switch IP address:
//IP address of the switch. This IP address must be in the same
network segment as that of the PC that saves the file to be downloaded.
Switch IP address: //IP address of the PC that saves the file to be downloaded.
Step 5: Enter the TFTP parameter values and press <Enter>. The system displays the
following information:
Are you sure to update your bootrom? Yes or No(Y/N)