H3C S7502 Ethernet Switch Installation Manual

Installation Manual
H3C S7502 Ethernet Switch Chapter 3 Installation Preparations
3-6
3.4 Installation Tools
Table 3-4 Required installation tools list
Tool
classification
Tool purpose Tool
Measure and
lineation tools
Long tape, ruler (of 1 meter), level, marking pen,
powder marker and pencil
Drills
A percussion drill, several auxiliary drill bits, a
vacuum cleaner
Fastening
tools
Flat-blade screwdriver P4-75mm
Phillips screwdriver P1-100mm, P2-150mm and
P3-250mm
Socket wrench 5.0kgf.cm
Box-end wrench M6
Box-end wrenches (10-12) or open-end wrench
(10-12)
Small tools
Sharp-nose pliers, diagonal pliers, vices,
hand-held electric drill, file, handsaw, crowbar
and rubber hammer
General tools
Auxiliary tools
Hair brush, tweezers, paper knife, hand bellows,
electric iron, solder wire, fork and ladder
Special tools
ESD-preventive wrist strap, cable stripper, crimping pliers, RJ-45
crimping pliers and wire punchdown tool
Fiber cleaner
tools
Tissue paper, microscope
Instruments
Multimeter, 500V Meg-ohmmeter (used to measure the insulation
resistance), error detector, optical power meter and earth
resistance tester
 Note:
No instruments or tools are shipped with the S7502, so you need to prepare them by
yourself.